Given the advantages of fiber cleavers, they are both clear and impressive for potential buyers. They guarantee a neat cut every time, and this means better signal transfer with lower loss. 1st of all, fibre cleavers save time and money. They can not merely reduce much labor from the basic production procedure but also speed up it. 2ndly, these devices will serve you for a long time. Rather than being just another immediate expense like using diamond disk or any other frequently replaced consumable, the replacement cost is relatively low. Because fibrous slivers will stick to the cutting edge of a regular (ceramic) cleaver blade after they have been cut and it is hard for them to get off, it takes some effort in removing them with an iron scraper knife; if all you have is steel then you need one of those too So by using a fibre cleaver you can fully expect to reduce the risk of problems connecting and increasing efficiency. These little things jack all your work up become such paltry affairs that one is hardly in touch with his present occupation at all!